|
ROUGHING APPLICATIONS
Series 101 Roughing End Mills are designed for space
age exotic materials, like titanium & nickel based/high
temperature alloys (inconel, rene, wasploy, etc). Its hi-helix
& fine profile geometry reduces tool pressure & generates
less heat while allowing heavier cuts at increased feed rates.
Series
102 Roughing End Mills are designed for light materials
like aluminum, brass, copper, etc. The 3 flute hi-helix roughing
geometry produces a manageable chip that gives maximum feed
rates in profiling & slotting applications. Also used
in general purpose applications for deep slots. The form relief
of both Series creates a smoother running tool.
HELIX
ANGLE:
· 3/16" thru 1" = 40 degrees
TOLERANCES:
· Shank: -.0001/-.0004
· Cutting Diameter: +.000/-.005
CORNER RADIUS:
(To strengthen end teeth)
·
3/16" = .025/.035
· 1/4" thru 5/16" = .040/.050
· 3/8" thru 1" = .055/.065
SET
SCREW FLATS:
· Standard on 3/8" thru 1"
UPON REQUEST:
· Coolant Slots, 1/4" thru 1"
· LASER Coating on both Series
· ZrN Coating on Series 101
· AlTiN Coating on Series 102
|
